The administrator can preset the maximum number of pages that each department will be allowed to print. To print a network status page, see Printing a Network Interface Status Page on page which follows. Feeding curled postcards may cause paper jams. The message display toggles through the following paper types: Available character code sets vary depending on the current font. No responsibility is assumed if accidents occur while the user is following the instructions in this guide. The printer is capable of the following emulation modes:

Uploader: JoJoll
Date Added: 15 November 2009
File Size: 62.30 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 26966
Price: Free* [*Free Regsitration Required]

Normal 1 4 Press the U or V key to display the desired paper thickness. None 6 Press the U or V key to display the desired binding mode. A new waste toner box is included with the toner kit.

Kyocera FS-2000D Advanced Operation Manual: Ib-21e/ib-30 Network Interface Cards

Status indicator Flashes during data communication. Duplex printing is available for the following paper types: Each time you finish writing data, a memory card write information page is printed from the printer showing the information, but pertaining only to the data just written.

Printed sheets can be stacked in the face-down output tray or an optional face-up output tray. Consult the documentation supplied with the application software. You agree that ib-21r such copy shall contain the same proprietary notices as those appearing on the original.


IBE Software / CDs Download Center | ServiceWorld | KYOCERA Document Solutions

Paper Cassette Figure 2. See Chapter 5 Maintenance, section 5. Skewed-color printout Conduct color registration using the printer operator panel. The color calibration operation may be carried out automatically during recovery from the Sleep mode or during printing.

The printer can be equipped with several enhancement optional units as a paper feeder as PF, a duplex unit i-21e DU Can be stored Yes No: You can use the Y or Z key to move the cursor right and left. They could be damaged lb-21e static electricity.

kyovera The length can be set between and mm 8. If set toprinting will be continued immediately without any time interval. The default setting is Off Auto Continue disabled.

Kyocera Ibe Ethernet 10/ Internal Print Server | eBay

Paper Size Dial Paper Size Window Figure 2 Adjust the paper guides and paper stopper inside the paper cassette to the size of the paper to be used and load the paper into the cassette. Processing appears, then Waiting.

For more information on installing the toner containers, see Chapter 5 Maintenance, section 5. Recover from certain errors. Custom 1 6 Press the U or V key to display the desired paper type. Also included is a list of permanent parameters and their explanation needed when customizing your printer.


The default font can be one of the internal fonts or a font that is downloaded to the printer memory or stored on memory card or hard disk. The message Processing appears and the printer prints a status page.

Definable RAM disk size is to Further use, duplication or disclosure is subject to restrictions applicable to restricted rights software as set forth in FAR If a problem cannot be corrected, contact your Kyocera Mita dealer.

Pull the release lever on the left side guide and slide to the desired paper size. You may be required to produce a status page when requesting service to the printer.

Then a help message will appear to facilitate jam clearing in the location. No responsibility is assumed if accidents occur while the user is following the instructions in this guide.