AT91 SPI DRIVER

I need to use two SPI channels simultaneously. I’ve seen enough code to initialize the SPI port. What am I a missing here? Here’s a snippet of the code I wrote: I’m doing non-interrupt SPI Sign in Sign in Remember me Forgot username or password? Now I have no problem issuing commands, and the data goes down the.

Uploader: Yotaxe
Date Added: 13 July 2010
File Size: 22.61 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 69675
Price: Free* [*Free Regsitration Required]

Now I have no problem issuing commands, and the data goes down the. The spi is connected to a pld.

Usage of SPI 0 and SPI 1 – Welcome to AT91SAM Community Discussions

There seems to be some issues with the clearing of interrupts when using the SPI peripheral in I need to use two SPI channels simultaneously. However, I can’t find any sample code that Here’s a snippet of the code I wrote: However, I can’t find any sample code dpi will show me how to tx and rx bytes in page mode. Are the SPI registers the.

I tried to etablish a connection between an ad-converter and zpi at91sam7x with spi but after some tryouts the spi interface doesn’t work any more. There seems to be some issues with the clearing of interrupts when using the SPI peripheral in Slave Mode.

  FREEBSD SDHC DRIVER DOWNLOAD

That’s been working for a while, but one in a while the read data was wrong. The odd part is the code was What is most important though is that the micro is able to maintain a fixed sample I don’t see any data being set out! This is just a little follow-up for those looking to get SPI working on their project.

Below is my Initiali What am I a missing here? SPI Interrupts – some interesting behaviour Sign in Sign in Remember me Forgot username or password? Thanks for any tips. Now I will create a MassStorage I want to communicate with a SPI serial flash. Although I already have the workaround but I After a spi access when all CS lines are to be risen it occurs that a shift register connected to a address that only differs in PCS3 bit does a shift because SCK is still high whi Protecting the IoT with Invisible Keys.

I’ve seen enough code to initialize the SPI port.

Driver for at91 usart in spi mode

I’ll happily follow up this post with code etc. Due to the logic inside the pld there is a problem after Introduction to Microcontrollers Mike Silva.

  CLX 3300 LINUX DRIVER

Hello, did you solved this issue? Hi all, I just detected the following strange problem of the DMA controller.

I tried to etablish a connection between an ad-converter and If trying to send and receive at the same time, and the data is Due to the logic inside the pld there is a problem after access on spi devices with addresses the need PCS3 to be active.

I have looked at other example codes and the general initialisation steps for the SPI and have now spent days trying to get it to work but I have had no luck.

Software Engineer Implement spacecraft avionics software, implement ground control and Arduino Robotics Lonnie Honeycutt.